Table of Contents
Advertisement
programme. This activity increases the total
water consumption of a programme by
additional 4 litres and the total energy
consumption of a programme by additional 2
Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more
than one in the same cycle) may prolong the
programme duration by another 5 minutes
when it occurs at any point at the beginning
or in the middle of a programme.
All the consumption values mentioned in
this section are determined in line with
the currently applicable standard in
laboratory conditions with water hardness
2.5mmol/L (water softener: level 3)
according to the regulation: 2019/2022 .
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
How to set the water softener level
Make sure the appliance is un user mode.
1. Press
.
• The indicators
are off.
• The indicator
• The display shows the current setting:
e.g.
= level 5.
2. Press
repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
6.3 The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the final rinse.
When the rinse aid chamber is empty, the
rinse aid indicator turns on. If the drying
results are satisfactory while using multi-
tablets only, you can deactivate the
notification for refilling the rinse aid. However,
for best drying performance, always use rinse
aid.
12
ENGLISH
,
,
and
still flashes.
If standard detergent or multi-tablets without
rinse aid are used, activate the notification to
keep the rinse aid refill indicator active.
How to deactivate the rinse aid empty
notification
Make sure the appliance is in user mode.
1. Press
• The indicators
are off.
• The indicator
• The display shows the current setting.
–
= the rinse aid empty
notification is deactivated.
–
= the rinse aid empty
notification is activated.
2. Press
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity of
rinse aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
deactivates the rinse aid dispenser and no
rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press
.
• The indicators
are off.
• The indicator
• The display shows the current setting:
e.g.
= level 4.
– The levels of rinse aid range from
0A to 6A where 0A means no
rinse aid is used.
2. Press
repeatedly to change the
setting.
3. Press on/off to confirm the setting.
.
,
,
and
still flashes.
to change the setting.
,
,
still flashes.
and
Advertisement
Table of Contents
