Starting The Programme; Changing The Activated Programme End Time; Soaking Laundry; Adding Laundry - Siemens WU28UT65ES User Manual And Installation Instructions

Table of Contents

Advertisement

Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 29
Press inicio/pausa+carga.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 29
¡ The programme end time is set
and activated.
→ "Buttons", Page 23
Press inicio/pausa+carga.
1.
The activated programme end time
is paused.
Press termin. 
2.
shows the required programme
end time.
Press inicio/pausa+carga.
3.
The changed programme end time
is activated.
until the display
13.10 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press inicio/
pausa+carga.
To resume the programme, after
3.
the desired soaking time, press
inicio/pausa+carga.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press inicio/pausa+carga.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press inicio/pausa+carga.
5.
13.12 Cancelling the pro-
gramme
Press inicio/pausa+carga.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
programme.
– If the water level is high, start
the
programme or select a
suitable programme for draining.
→ "Programmes", Page 24
operation en
31

Advertisement

Table of Contents
loading

Table of Contents