Advertisement
WHAT'S INSIDE:
A
Handheld Vacuum
B
Dirt Engage™ Floor Nozzle
C
MultiFLEX™ Wand
Upholstery Tool
D
8" Crevice Tool
E
Self-Cleaning Pet Power Brush
F
Charger
G
Li-Ion Battery (Pre-Installed)
H
HEPA Post Motor Filter (Pre-Installed)
I
D
E
G
H
F
For complete maintenance instructions, see the enclosed Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
ASSEMBLY
A
F
C
B
OFF
Slide switch to the
top to turn off power.
To begin vacuuming
in Standard Mode,
slide switch to the
appropriate setting.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the
trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
2
(Click)
IN THE
VACUUM
1
In Use
(Click)
Full
Charge
Charging
Low
Charge
NOTE: Full charge takes approximately 3 hours.
POWER SETTINGS
BARE FLOOR
CARPET SETTING
SETTING
Bare Floor/Area Rugs
Carpet
The brushroll spins slowly
The brushroll spins
to clean bare floors and
faster to pick up debris
small area rugs.
below the surface
of your carpets.
CHARGING
BATTERY
OUT OF
BATTERY RELEASE
INDICATOR
THE VACUUM
BUTTON
LIGHTS
LI-ION BATTERY
Mid
Low
Nearly
Charge
Charge
Empty
Mid
Nearly
Full
Charge
Full
Charge
BOOST MODE
For an added boost in
power, pull the Trigger
on the handheld vacuum.
Release it to return to
standard power.
Easily Insert or Remove
the Li-Ion Battery
To insert, slide the Li-Ion
Battery into the slot in
the back of the handheld
vacuum. To remove, press
and hold the Battery
Release Button then slide
out the Power Pack.
NOTE:
The battery comes
partially charged. Charge fully
before first use.
No
Battery Run Time
Charge
MODE
MINUTES
Hand Vac
40
Bare Floor/
25
Standard Mode
Carpet Mode
20
Boost Mode
10
(Hand Vac)
©2020 SharkNinja Operating LLC.
Advertisement
