Table of Contents
Advertisement
Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
Every 200 hours
Before storage
Lubricating the Bucket
Service Interval: Before each use or daily
Every 200 hours
Using a grease gun, pump general purpose grease
into the six grease fittings on the 4-in-1 bucket until
the grease begins to ooze
excess grease with a shop cloth.
1. Grease fittings
Maintenance Procedure
• Lubricate the bucket
• Ensure that all fasteners are securely tightened.
• Inspect the hydraulic system for leaks and loose fittings.
• Clean the areas around the bucket cylinder and mount plate pivot.
• Check for wear of pins, linkages, and cutting edges.
• Grease the bucket pivot points.
• Lubricate the bucket
• Inspect the hydraulic system for leaks and loose fittings.
• Inspect the hydraulic system for leaks and loose fittings.
(Figure
9). Wipe away any
Figure 9
Storage
1.
Before long-term storage, wash the attachment
with mild detergent and water to remove dirt and
grime.
2.
Check and tighten all bolts, nuts and screws.
Repair or replace any part that is damaged or
worn.
3.
Ensure that all the hydraulic hose couplers are
connected together to prevent contamination
entering the hydraulic system.
4.
Paint all scratched or bare metal surfaces.
Note:
Paint is available from your Authorized
Service Dealer.
5.
Grease the pivot points; refer to
Bucket (page
6.
Store the attachment in a clean, dry garage or
storage area.
7.
Cover the bucket to protect it and keep it clean.
g006224
9
Lubricating the
9).
Advertisement
Table of Contents
