Cleaning And Maintenance Of The Oven's Front Door Glass; Catalytic Walls; Rack Positions - Nevir NVR-CB5PHW User Manual

Cleaning And Maintenance Of The Oven's Front Door Glass

Remove the profile by pressing the plastic latches on both left and right
sides as shown in figure 24 and pulling the profile towards yourself as
shown in figure 25. Then remove the inner-glass as shown in figure 26.
If required, middle glass can be removed in the same way. After cleaning
and maintenance are done, remount the glasses and the profile in reverse
order. Make sure the profile is properly seated in its place.
Figure 24

Catalytic Walls *

Catalytic walls are located on the left and the right side of cavity under the
guides. Catalytic walls banish the bad smell and obtain the best performance
from the cooker. Catalytic walls also absorb oil residue and clean your oven
while it's operating.
Removing the catalytic walls
In order to remove the catalytic walls; the guides must be pulled out.
As soon as the guides are pulled out, the catalytic walls will be released
automatically. The catalytic walls must be changed after 2-3 years.

Rack Positions

Rack 4
Rack 3
Rack 2
Rack 1
Figure 25
It is important to place the wire grill into
the oven properly. Do not allow wire rack to
touch rear wall of the oven. Rack positions
are shown in the next figure. You may place
a deep tray or a standard tray in the lower
and upper wire racks.
39
2
1
Figure 26