Garland SET 802 G Instruction Manual page 41

It is always necessary to stop the machine, wait
for the blades to stop before carrying out any cleaning
or maintenance work on the machine and when
transporting the machine.
Before performing any maintenance or repair
the machine make sure the engine is off and
remove the spark plug cap. Any changes
should be done on a flat and stable surface.
Carry out all maintenance work on a flat surface and
on a clear surface.
WARNING! Do not change the machine or its cutting
elements. An incorrect change to these elements
could cause SEVERE PERSONAL DAMAGES OR DEATH.
Only use original spare parts and accessories for this
machine so as to obtain the best performance from
the machine. These spare parts and accessories can
be found in the official distributors of the brand. The
use of other spare parts and accessories could result
in risks to the end user, people who are nearby and to
the machine.
Carburettor adjustment is a complex procedure and
must be carried out by the after sales service.
The removal of the security elements, a poor
maintenance or the substitution of spares and
accessories by non original ones can all cause severe
corporal damages.
8.1. MAINTENANCE AFTER USAGE
Carry out the following maintenance work once
you finish your task to guarantee that the machine
functions correctly next time.
8.1.1. CLEANING
Maintain the machine clean, specially the petrol
deposit area and the area near the air filter.
Attention! The cutting tool are sharp and can cause
damage. Use protection gloves when cleaning the
machine.
Use a brush to clean the blade. Never use petrol,
detergents, water or any other liquid to clean the
blades.
8.2. PERIODIC MAINTENANCE
Make periodic inspections of the machine to ensure
that the machine is correct. For a thorough inspection
take the machine to your dealer.
Use always original spare parts and accessories
so as to achieve the best performance from the
machine and to avoid damages to the end user and
the machine. The use of non original spare parts and
accessories can cause accidents, personal damages
and machine breakage.
8.2.1. PETROL FILTER
The petrol deposit is equipped with a filter. It is located
in the extreme of the aspiration petrol tube and can be
removed using a wire shaped like a hook.
Check the petrol filter periodically. Do not allow dirt to
enter the petrol deposit to avoid the filter getting dirty.
A dirty filter will difficult the engine starting and will
provoke instability and in extreme cases, the machine
might even stop.
Check the petrol. If you observe dirt, replace it.
41/144
English