Reversing The Door - Hisense RB440N4BCE User's Operation Manual

Reversing the door

The side at which the door opens
can be changed, from the right side
(as supplied) to the left side, if the
installation site requires.
Warning! When reversing the door,
the appliance must not be connected
to the mains. Ensure that the plug is
removed from the mains socket.
Tools you will need
Not provided
8mm socket wrench Thin-blade screwdriver
Cross-shaped screwdriver
When required, tilt the refrigerator
●
back in order to gain access to the
base, you should rest the appliance
on soft foam packaging or similar
material to avoid damaging the
backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
Different models may correspond to
different pictures. Models will be
written in the picture. If some parts
are not shown in the picture, please
ignore the relevant description.
1. Stand the refrigerator upright.
Open the upper door to take out all
door racks (to avoid racks damaged)
and then close the door.
2.Remove part
the top right side of refrigerator.
3.Remove screws
.When the refrigerator with
②
8mm wrench
display on door, you need to pass
connector
hinge
hand when installing).
Door racks
①, loose part
① Self-tapping screws
② Upper hinge cover
① and hinge
③ through the hole of
②. (Please hold upper door by
① Special flange screws
② Upper hinge
MODEL WITHOUT DISPLAY
① Special flange screws
② Upper hinge
③ Electrical connector
MODEL WITH DISPLAY
10
② from