Installing And Charging The Battery - LOGICOM VR BOT 552 Quick Start Manual

3. Inserting a MicroSD
It is possible to increase the internal memory of the Smartphone device with a MicroSD card. (Maximum 32GB
MicroSD card).
• Switch off the phone and remove the rear cover and battery.
• Insert the memory card into the relevant slot.
• Then replace the battery and cover.
CAUTION: Inserting or removing a SIM card or a MicroSD card requires the Smartphone to be completely switched
off.

4. Installing and charging the battery

Installing the battery:
•
Remove the rear cover of your Smartphone.
•
Insert the battery ensuring that the image shown here is facing you.
•
Replace the rear cover of the Smartphone.
CAUTION
: Risk of explosion if battery is replaced by an incorrect type.
Model: F38014A (Li-Po – 3.8V – 3000mAh)
To replace the battery, please enquire with the after-sales service of your dealer.
Dispose of used batteries according to the instructions.
Charging the battery:
•
To charge the battery, connect the USB cable (supplied) to the USB port of your Smartphone and the
other end to the mains adaptor (supplied). Then connect the mains adaptor to a power outlet.
•
The battery charge icon illuminates during charging and indicates the charge status.
•
When the battery is fully charged, you can disconnect the USB cable from the device then from the
power outlet.
IMPORTANT:
•
The Smartphone is only recharged via its USB port.
•
Ensure your Smartphone is fully discharged before charging it for the first time.
•
The battery must be charged for at least 5 to 8 hours when first charged.
•
After a long period without use, It should be necessary to do many cycles of charging / discharging to
obtain maximum power capacity
Note: You can use the device when it is being charged. In this case, the battery may take longer to charge fully.
Safety information for charging the battery:
•
To recharge the battery, only use the mains adaptor supplied with your device. Do not use any other
power supply or electrical device.
•
The power outlet to which the device is connected must be near the equipment and must always be
easily accessible.
•
Always wait at least 5 seconds after switching off the device before restarting it. Switching the device
off and then back on again immediately may damage the electrical circuits.
•
Do not disassemble, open or shred the battery contents. Do not dispose of batteries in fire or water.
Do not charge the battery if the room temperature exceeds 45° C. Keep the battery in a clean and dry
place. Avoid leaving the battery under sunlight.
•
Do not short circuit the battery. Do not keep the battery in a place where it can be shorted by other
metal objects.
4