Page 1
KS 55 KS 55 FS de Originalbetriebsanleitung 4 Alkuperäinen käyttöopas 43 en Original instructions 9 no Originalbruksanvisning 48 Notice d'utilisation originale 14 da Original brugsanvisning 53 Originalbetriebsanleitung 19 Instrukcja oryginalna 58 Istruzioni per l'uso originali 24 Πρωτότυπες οδηγίες λειτουργίας 63 es Manual original 29 hu Eredeti használati utasítás 69...
The machine is not designed for plunge cuts. h) Never use damaged or incorrect saw blade While the KS 55 FS is suitable for work with the plain washers or bolt. The blade washers and bolt Metabo guide rail (6.31213), the KS 55 is not.
Page 5
ENGLISH c) When restarting a saw in the workpiece, centre the saw blade in the kerf so that the saw Wear protective goggles. teeth are not engaged into the material. If a saw blade binds, it may walk up or kickback from the Press the spindle locking button only when the workpiece as the saw is restarted.
(KS 55 FS is illustrated as an example.) against the guide plate. (8) Read the angle which has been set from the scale (3). Tighten the locking 1 Screws (KS 55 FS only). With the screws (2)screws again. released, you can adjust the play and thus the sliding movement of the guide rail by shifting the For a diagonal cut angle of 47°, push down the...
(16). It is best to calculate the exact cut width by making a test cut. 10. Repairs Sawing with a guide rail (for KS 55 FS only): This can be used to make straight-line, tear-free cut Repairs to electrical tools must be carried out edges that are millimetre-precise.
Page 8
ENGLISH en Using these values, you can estimate the emissions from this power tool and compare these with the values emitted by other power tools. The actual values may be higher or lower, depending on the particular application and the condition of the tool or power tool.
Need help?
Do you have a question about the KS 55 and is the answer not in the manual?
Questions and answers