Using The Sony Tv Direct Function - Sony DHC-FLX9W Operating Instructions Manual

Using the SONY TV DIRECT
function
SONY TV DIRECT allows you to turn on your
SONY TV and this system, change the system
mode to "DVD", and then switch the TV's input
source you set with one button push.
Use the remote for the operation.
1
Press and hold TV/VIDEO while
entering the code for the TV's input
source connected to this system (see
the table below) using the numeric
buttons.
TV's input source is selected.
By pressing Number
TV/VIDEO 0
1
2
3
4
5
6
7
8
2
Press and hold TV CH + while entering
the code for transmit time (see the
table below) using the numeric
buttons.
The transmit time from the remote is
selected.
By pressing Number
TV CH + 1
2
3
4
5
6
7
8
TV's input source
No input source
(Default)
VIDEO1
VIDEO2
VIDEO3
VIDEO4
VIDEO5
VIDEO6
COMPONENT 1
INPUT
COMPONENT 2
INPUT
TV's input source
0.5
1
1.5 (Default)
2
2.5
3
3.5
4
Notes
• This function is only for SONY TV series, however,
some TV products may also not work.
• If this function does not work, change the transmit
time. The transmit time varies depending on the TV.
• If distance between the TV and this system is too far,
this function may not work. Install the system near
the TV.
• Keep the remote pointed in the direction of the TV
and this system.
GB
61