AEG TAB6L88EF User Manual page 15

Problem
The compressor operates continual‐
ly.
The compressor does not start im‐
mediately after pressing the "Frost‐
matic", or after changing the temper‐
ature.
Door is misaligned or interferes with
ventilation grill.
Door does not open easily.
There is too much frost and ice.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Possible cause
The door is left open.
Temperature is set incorrectly.
Many food products were put in at
the same time.
The room temperature is too high.
Food products placed in the appli‐
ance were too warm.
The door is not closed correctly.
The Frostmatic function is switched
on.
The compressor starts after a period
of time.
The appliance is not levelled.
You attempted to re-open the door
immediately after closing.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Frostmatic function is switched
on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Solution
Close the door.
Refer to "Control panel" chapter.
Wait a few hours and then check the
temperature again.
Refer to "Installation" chapter.
Allow food products to cool to room
temperature before storing.
Refer to "Closing the door" section.
Refer to "Frostmatic function" sec‐
tion.
This is normal, no error has occur‐
red.
Refer to installation instructions.
Wait a few seconds between closing
and re-opening of the door.
Refer to "Closing the door" section.
Refer to "Closing the door" section.
Wrap the food products better.
Refer to "Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
Attach the melting water outlet to
the evaporative tray.
Switch off Frostmatic function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "Frostmatic func‐
tion" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
ENGLISH 15