Installation of the rear cover adhesive tape kits
Ensure that you attach the adhesive tapes properly as shown below.
Note: When installing the rear cover, press the whole area of the rear cover to ensure that it is installed
firmly.
1030 Heatsink
For access, remove this FRU:
• "1010 Rear cover " on page 57
• "1020 Rear cover adhesive tape kits" on page 59
Removal steps of the heatsink
Note: Ensure that you hold the lateral side of the vapor chamber in either of the ways as shown below. It is
not recommended that you hold only the heat pipe part by hand. Otherwise, the heat pipe might bend.
60
X1 Fold 16 Gen 1 Hardware Maintenance Manual
F
B
E
D
1e
1c
1b
1d
H
A
A
C
1a
1f
1g
G
I