Table of Contents
Advertisement
1010 Rear cover
Removal steps of the rear cover assembly
Use rear cover removal screw in step
head to lift up the rear cover from the screw hole.
Note: The length of the screwdriver head should be less than or equal to 7mm.
Note: Use the pry tool to insert from the areas near the two screw holes to pry up the rear cover. Do not
insert from the other areas. Otherwise, it might cause component damage.
Step
Screw (quantity)
1
M2.5 × 2.5 mm, flat-head, nylon-coated (2)
2
as shown below. You can also use a alterative tool like screwdriver
Color
Torque
Black
0.29 Nm
(3.0 kgf-cm )
.
Chapter 7
Removing or replacing a FRU
57
Advertisement
Table of Contents
