Extension Cords - Craftsman 315.277011 Owner's Manual

_1, WARNING: When servicing use only identical
Craftsman replacement parts. Use of any other
parts maycreato a hazard or cause product
damage.
GENERAL
Only the parts shown on parts list, page thirteen, are
intended to be repaired or replaced by the customer.
All other parts represent an Important part of the
double insulation system and should be serviced only
by a qualified Sears service technician.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use, Use clean cloths to remove dirt, carbon
dust, etc,
_ WARNING: Do not at any time let brake fluids,
gasoline, petrolaum-basod products, penetrating
oils, etc. come in contact with plastic pads. They
contain chemicals that can damage, weaken, or
destroy plastic.
It has been found that elactdc tools are subject to
accelerated wear and possible premature failure when
they are used on fiberglass boats, sports cars,
wallboard, spackling compounds, or plaster. The
chips and gdndings from these materials are highly
abrasive to electric too! paris such as bearings,
brushes, commutators, etc. Consequently, it is not
recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds, or piaster. During any use on these
matedals it is extremely important that the too! is
cleaned frequently by blowing with an air jet.
EXTENSION CORDS
The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent
tool from overheating, use an extension cord that is
heavy enough to carry the current the tool will draw,
A wire gage size (A.W,G.) of at least 16 Is recom.
mended for an extension cord 100 feat or less in
length. When working outdoors, use an extension
cord that is suitable for outdoor use. The cent's jacket
will be marked WA.
_, CAUTION: Keep extensioncurds away fromthe
sending area endpositionthe cordsothat it will
not get caught on lumber, tools, etc. during
sanding.
WARNING: Check extension cords before each
use. If damaged replace immediately. Never use
tool with a damaged cord since touching the
damaged area could cause electrical shock
resutiing in sedous injury.
Extension cords suitable for use with your sander aie
available at your nearest Sears Retail Store,
_k WARNING: Always wear safety goggles or
safety glasses with side shields dudng power tool
operation or when blowing dust. If operation is
dusty, also wear a dust mask.
LUBRICATION
All of the beadngs in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore,
no further lubrication is required.
I0