Advertisement
WARNING:
When servicing, use only identical
Craftsman replacement parts, Usa of any other part
may create a hazard or cause productdamage,
G EN ERAL
Only the parts shown on parts list, page 13, are
intendedto be repaired or replaced by the customer.
All other parts represent an importantpart of the
double insulationsystem and shouldbe servicedonly
by a qualified Sears service technician,
Avoid using solventswhen cleaning plastic parts.
Most plasticsare susceptibleto damage from various
types of commercial solventsand may be damaged
by their use, Use clean clothsto remove dirt, carbon
dust, etc.
_L WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products,penetrating
oils, etc. come in contact with plasticparts, They
contain chemicalsthat can damage, weaken or
destroy plastic.
It has been found that electric tools are subjectto
accelerated wear and possible premature failure when
they are used on fiberglass boats, sportscars,
wallboard, spacklingcompounds,or plaster. The
chipsand gdndingsfrom these materialsare highly
abrasive to electric tool parts such as bearings,
brushes,commutators,etc. Consequently, it is not
recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds,or plaster. During any use on these
materials it is extremely importantthat the tool is
creanedfrequently by blowing with an air jet.
&
WARNING: A/ways wear safety goggles or
safety glasses with side shields during power tool
operation or when blowing dust. If operation is
dusty, also wear a dust mask,
LUBRICATION
All of the beadogs in this tool are lubricatedwith a
sufficientamount of high grade lubricantfor the life of
the unit under normal operating conditions,Therefore,
no further lubncationis required.
EXTENSION
CORDS
The usa of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent
tool overheating,usa an extension cord that is heavy
enough to carry the currentthe tool will draw,
Awire gage size (A.W,G.) of at least 16 is
recommendedfor an extensioncord 100 feet or less
in length, When workingoutdoors, use an extension
cordthat is suitablefor outdoor use. The cord'sjacket
will be marked WA.
CAUTION:
Keep extension cords away from the
sandingarea and positionthe cord so that it will
not get caught on lumber,tools, etc., during
sanding operation,
,_k WARNING: Check extension cords before each
use, If damaged replace immediately.Never use
tool with a damaged cord since touchingthe
damaged area could cause electrical shock
resulting in serious injury,
Extension cords suitablefor use with your sander are
available at your nearest Sears Retail Store.
Advertisement
