Table of Contents
Advertisement
2nd
3rd
Input Port Ver.
Auto Source Switch
Key Repeat Time
Power LED On
Description
Select an HDMI version.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode
to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
― Set
HDMI Mode
to
1.4
if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
No Repeat
is selected, a command responds only once when a button is pressed.
28
Advertisement
Table of Contents
