Storage; Troubleshooting - Philips AC1715 User Manual

6

Storage

1 Turn off the air purifier and unplug from the power socket.
2
Clean the air purifier, particle sensor and the surface of the filter (see chapter "Cleaning and
maintenance").
3
Let all parts air dry thoroughly before storing.
4
Wrap the filter in air tight plastic bags.
5
Store the air purifier, filter in a cool, dry location.
6 Always thoroughly wash hands after handling the filter.
7

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, contact the Consumer Care Center in your
country.
Problem
The appliance does not
work even though it is
plugged in.
The airflow that comes
out of the air outlet is
significantly weaker
than before.
The air quality does not
improve, even though
the appliance has been
operating for a long
time�
The color of the air
quality light always
stays the same.
Possible solution
• The filter replacement alert has been flashing continuously but you have
not replaced the corresponding filter. As a result, the appliance is now
locked. In this case, replace the filter and long touch
the filter lifetime counter.
• The surface of the filter is dirty. Clean the surface of the filter (see the
chapter "Cleaning and maintenance").
• Check if the packing material is removed from the filter.
• The filter has not been placed in the appliance. Make sure that the filter
(FY1700/30) is properly installed.
The particle sensor is wet. The humidity level in your room is high and
•
causes condensation. Make sure that the particle sensor is clean and dry
(see the chapter "Cleaning and maintenance").
• Room size is large or the outdoor air quality is poor.
For optimum purification performance, please close the doors and
windows when operating the air purifier.
• There are indoor pollution resources. For instances, smoking, cooking,
incense, perfume or alcohol.
• Filter reaches the end of life. Replace the filter with a new one.
The particle sensor is dirty. Clean the particle sensor (see the chapter
•
"Cleaning and maintenance").
and to reset
EN
15