Table of Contents
Advertisement
_,
WARNING:
Never connect the router to power
supply when you are assembling parts, making
adjustments, installing or removing cutters, or
when not in use. Disconnecting the router prevents
accidental starting that could cause serious injury.
REMOVING AND INSTALLING
THE ROUTER
BASE
TO SWITCH FROM THE FIXED BASE OR D-HANDLE
BASE TO THE PLUNGE BASE
See Figures 2 and 3.
TO REMOVE THE FIXED OR D-HANDLE BASE:
1. Unplug the router,
,_
WARNING:
Failure to unplugthe tool could result
in accidental starting causingserious.
2.
Place the router upside down with the Craftsman
label away from you.
3.
Loosen the locking arm on the base.
4.
Depress and hold the gold spindle lock button. The
gold spindle lock button will not depress fully unless
it is in line with the hole in the collet.
5.
Ifthe goldspindle lockbutton does not depress fully,turn
the collet nut while depressingthe gold spindle lock
button.As they align,the gold spindlelock button will
depress fully.
6. Turn the depth adjusting ring counterclockwise until
the motor is to its highest position. NOTE: As the
motor is rising, the gold spindle lock button has to
be depressed until it clears the rear window.
7.
Align the indicator arrow on the depth adjustment
ring with the indicator point on the base.
8.
Pull the base until it dislodges from the motor
housing.
TO INSTALL THE PLUNGE BASE
1.
Unplug the router.
2.
Place the plunge base on a flat surface.
3.
Loosen the locking knob.
4.
Align the groove in the motor housing with the rib
inside the base. NOTE: The rib is located on the
inside of the base in line with the handle.
5.
Depress and hold the gold spindle lock button.
6.
Slide the motor housing into the base.
7. Tighten the locking knob.
_,
CAUTION: Do not tighten the locking knob without
the motor installed in the base. Failureto heed this
caution may resultin permanent damage to the
lockingmechanism.
ADJUSTMENT
RING
INDICATOR
INDICATOR
POINT
GOLD
SPINDLE
LOCK
BUTTON
LOCKING
ARM
DEPTH ADJUST-
MENTRING
GROOVE IN
MOTOR..
HOUSING
RIBINSIDE
THE BASE
@
Fig. 2
Fig. 3
10
Advertisement
Table of Contents
