Advertisement
IMPORTANT:
Read the following safety and operation instructions to avoid injury and to avoid damage to equipment or property.
CAUTION: Unit light bulb may smoke upon initial start up. However, this does not cause a fire issue.
Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration for this unit. We recommend usage
!
on an individual branch circuit of at least 15 amps for best results. Failure to do so may result in decreased performance of the warmer.
Only shatter resistant compact fluorescent light bulbs which meet or exceed NSF Standards specifically designed for food holding
!
units must be used. Breakage of bulbs not specially coated could result in personal injury and/or food contamination.
Use of non-compact fluorescent bulbs may result in warping and/or melting of acrylic.
!
Exterior surfaces on unit may get hot. Use caution when touching these areas to avoid injury.
!
Unplug unit from power source and allow to cool completely before performing any maintenance or cleaning.
EQUIPMENT SET UP
Once the unit has been taken out of the shipping carton and has been unpackaged, check to make sure that all light
bulbs are securely in their sockets.
Remove & discard any plastic film that may be on your unit protecting it from scratches during transit.
CLEANING INSTRUCTIONS
!
Unit is not waterproof. Do Not submerge in water. Do not operate if unit has been submerged in water.
!
Unplug unit from power source and allow to cool completely before performing any maintenance or cleaning.
!
The use of any type of ammonia, alcohol or chlorine based household cleaners will cause cracking of the door/enclosure and is
not covered under any warranty. Use warm soapy water and a soft cloth only.
It is recommended that the interior and exterior surfaces be cleaned daily with a mild soap and damp cloth.
Stubborn stains on base of unit and/or racks may be removed with a non-abrasive cleaner and a
damp cloth. Usage of an abrasive cleanser could scratch or damage the finish of your unit.
The use of any type of ammonia, alcohol or chlorine based brand name household cleaners will cause
cracking of the enclosure/doors and is not covered under warranty. Clean unit with warm soapy water
and soft cloth only.
Step 1: Unplug unit from electrical supply
Step 2: Let unit cool before cleaning
Step 3: Clean daily with warm soapy water and a soft cloth only.
To Remove Outlet Cover:
- Pull back and then lift cover off
P .O. Box 10 • Oregon, WI 53575 • Ph: 608.835.3106 • Fx: 608.835.8273 • wiscoind.com • wiscomade.com
Advertisement
