ADTRAN jobAid+ 1200487G10 Manual

CLEI: BVL3ALED_ _
Product P/N: 1200487G10
D
ESCRIPTION
The Small Form-Factor Pluggable (SFP) Gigabit Ethernet,
Single-Fiber is a bidirectional SFP that plugs into an
Optical Network Unit (ONU) designed to accept SFPs. The
SFP provides a single optical interface to the GigE physical
interface. Installed into an appropriate ONU, the SFP
provides a Gigabit Ethernet interface to the supporting
system.
NOTE
To ensure compatibility, refer to the documentation
provided with the ONU.
NOTICE
In a deployment consisting of an ONU with a 1200487G10
SFP installed; the Optical Loop Termination (OLT) should
have a complementary 1442110G1 SFP installed.
Rx: 1310 nm
OLT
Tx: 1490 nm
1442110G1
The following features are supported on the SFP:
1000Base-LX 1310 nm Transmitter
♦
♦ 1000Base-LX 1490 nm Receiver
♦ Optical distance: 10 km maximum
!
CAUTION
Due to compliance certification requirements, only SFPs
supplied by ADTRAN should be used. ADTRAN cannot
certify system integrity with other SFPs.
Small Form-Factor Pluggable
1310 nm TX / 1490 nm RX, 10 km
Rx: 1490 nm
ONU
Tx: 1310 nm
1200487G10
Operational Specifications
♦ Optical Specifications:
◊ Transmit wavelength: 1310 nm
◊ Receive wavelength: 1490 nm
◊ Optical transmit level: –9 dBm to –3 dBm
Optical receive level: –19.5 dBm to –3 dBm
◊
Optical distance: 10 km
◊
◊ Optical connectors: LC
♦ Extended Environmental Support:
◊ Operational temperature range: –40°C to +85°C
◊ Storage temperature range: –40°C to +85°C
◊ Relative humidity to 95%, noncondensing
I
NSTALLATION
Prior to installation, inspect the SFP. If damage has occured
during shipping, file a claim with the carrier, and then
contact ADTRAN Customer Support. For more infor-
mation, refer to "Warranty".
To install the SFP into an appropriate module, complete
the following steps:
1. Insert the SFP into the SFP cage on the circuit board of
the host module with the latch handle facing outward.
Slide the SFP all the way into the cage.
NOTE
The latch on the SFP is for removal only. When removing
the SFP, rotate the latch away from the SFP, the SFP should
slide easily out of the cage.
2. Exert adequate pressure to ensure the SFP is
completely seated in the SFP cage.
3. Do not remove the connector plug until the optical
fiber connection is made.
NOTICE
It is recommended that the connector plug remain on
whenever the transciever optical fiber connector is not
inserted.
4. Continue the installation and turn-up of the host
module using the instructions in the Job Aid provided
with the module, or use the Installation and
Maintenance Guide (I&M) available online at
www.adtran.com.
jobAid
Issue Date: January 2011
Document P/N: 61200487G10-22A