Installation; Before Installing - LG WS9D76 Series Installation Manual

INSTALLATION

6
INSTALLATION

Before Installing

Before Beginning
Remove all tape and packing materials before
using the oven. Dispose of all plastic bags after
unpacking the oven.
Never allow children to play with packing materials
CAUTION
• Make sure the cabinets and wall coverings
around the oven can withstand the temperature
(up to 95 ) generated by the oven.
7
• Fronts of nearby units up to at least 70
- Discoloration, delamination or melting may
occur.
• During installation, ensure that no persons can
come into contact with live components.
• The oven must be installed by a qualified
professional electrician, in accordance with the
corresponding regulations and standards.
• The oven is a heavy appliance and must be
transported with great care.
• Before initial use, remove all packaging, both
external and from inside the appliance.
• No modification may be made to the oven's
technical characteristics.
• The integrated cooking area or hotplates is/are
provided with special connections. These may
only be attached to the appropriate
corresponding connections of the same type.
NOTE
This installation must be completed by a qualified
installer or technician.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
• Consumer: please read and keep these
instructions for future reference and be sure to
read the entire OWNER'S MANUAL prior to use.
• Do not use the parts except for provided
components when you install the product.
• Make sure the oven is flush with the front of the
enclosure.
• A malfunction can occur if the steam oven is not
correctly aligned. For correct functioning of the
steam generator please make sure that the
steam oven is horizontally level. (On some
models)
• When mounting built-in cabinet, decide the
dimension of the built-in cabinet's depth so that
the offset between door glass face and front
surface of the left and right side furniture will be
less than 1 mm.
.
7
Installation Information
The first step of the installation is measure the
current cutout dimensions and compare them to
the cutout dimensions shown below. Little or no
cabinet work may be necessary.
NOTE
Make sure the base is level and the front of the
cabinet is square. If the cabinet base is not level,
the oven glides will tend to slide out when opening
the door.
• To lift oven, use side holes of the oven.
• Kitchen cabinets in contact with the oven must
be heat resistant up to 95
nearby units up to at least 70
• Do not install dishwasher under the oven.
• Do not install the product on the floor.
7 , and fronts of
.
7