Nikon F5 Instruction Manual page 89

7 AE Lock when shutter release button is lightly pressed:
At the default setting, exposure does not lock when the
shutter release button is lightly pressed. To lock exposure
when the shutter release button is lightly pressed, select
in Custom Setting.
8 Auto film loading when camera back is closed: At the
default setting, loaded film is advanced to frame #1 when
the camera back is closed and the shutter release button is
fully depressed once. By selecting
film automatically advances to frame #1 when the camera
back is closed after film loading.
9 Film advance speed in C
speed to 6 fps from 7.4 fps with AA-type alkaline or lithium
batteries or 8 fps with Ni-MH Battery Unit in (C
Continuous High-Speed film advance mode, select
10 Film advance speed in C
speed to 5 fps or 4 fps from 3 fps in (C
Speed film advance mode, select
in Custom Setting,
: To change the film advance
H
)
H
: To change the film advance
L
) Continuous Low-
L
or .
11 Alert LED in
during exposure, select
12 Auto film stop: At the default setting, film advances until
the end of the film roll is reached. To stop film advance at
frame number 35 or 36, select
13 Multiple exposure: Multiple exposure mode is automati-
cally canceled when the second shot is taken. To continue
multiple exposure after the second shot, select
14 Center-Weighted Metering: 75% of the meter's sensitivity
is concentrated in the 12mm-dia. circle within the viewfinder
and 25% outside this circle in Center-Weighted Metering.
To change the size of the circle to 8mm, 15mm, 20mm,
average on entire viewfinder or create a custom-size (by
Computer Link) diameter, select
.
15 Time delay for auto meter-switch-off: Camera's meter
remains on approximately 8 seconds after the shutter
release button is pressed. To change the delay time to 4
sec., 16 sec. or 32 sec., select
exposure: To enable alert LED to blink
.
or .
, ,
, or
.
, or .
.
89