Dynex 9226KS7010 Service Manual page 11

NA04 5272402002
NA07 5272402002
NA04 5272402002
NA07 5272402002
Note：
To set write protection, the method is : enter into ALL-100 writing program AUTO interface, select
Config item (it must be selected when writing). In AUTO interface, click Config Setting, set Protect to
All Protect, SRWD to Enable. Pay attention that every time when ALL-100 writing program is
reopened, write-protection must be set again.
7. EEPROM initialization (not be used unless needed)
The method is: press IR POWER/KEYPAD POWER to turn on the TV, before showing LOGO press
INPUT SOURCE incessantly until the indicator lights red, then in turn press MENU, VOL+, CH+ (the
interval between two press is below 2 seconds), the indicator light will turn blue, after a while the unit
will be in STANDBY, that means RESET EEPROM succeeds. If error key order or key number or the
interval is over 2 seconds, the unit will keep on the previous setting and perform the order, then
EEPROM will not be cleared
ALIGNMENT INSTRUCTIONS
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
AT24C02BN10SU-1.8
HDMI2 Write with instrument like
EDID ALL11
HDMI3 Write with instrument like
EDID ALL11
HDMI1 Write with instrument like
EDID ALL11
HDMI2 Write with instrument like
EDID ALL11
10
Only for
32"/37"/42"/46"
models
Only for 26"
model