36
www.electrolux.com
3.5 Replacement of batteries in
remote controller
①
②
Fig.1
1.
Lift the cover along the direction of arrow
(as shown in Fig 1 ① ).
Take out the original batteries (as shown in
2.
Fig 1 ② ).
Place two 7# (AAA 1.5V) dry batteries, and make
3.
sure the position of " + " polar and " - " polar is
correct (as shown in Fig 2 ③ ).
Reinstall the cover (as shown in Fig 2 ④ ).
4.
NOTICE
●
During operation, point the remote control signal
sender at the receiving window on indoor unit.
●
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
●
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
●
Replace new batteries of the same model when
replacement is required.
'
●
When you don
t use remote controller for a long time,
please take out the batteries.
●
If the display on remote controller is fuzzy or there
no display, please replace batteries.
④
③
Fig.2
'
s