Page 10
SAFETY INSTRUCTION This manual explains the proper installation and use of your cooker hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: •...
Page 11
Always to do: • Always put lids on pots and pans when cooking on a gas cooker. • When in extraction mode, air in the room is being removed by the cooker hood. Please make sure that proper ventilation measures are being observed. The cooker hood removes odours from room but not steam.
Page 12
1. Before installation, turn the unit off and unplug it from the outlet. 2. The cooker hood should be placed at a distance of 65~75cm above the cooking surface for best effect. If the ceiling is low and hood is installed without extended chimney, there should be at least 3cm gap between the ceiling and chimney.
Page 13
4. Install the flow exit to the hood and follow by connecting the flexible exhaust duct to the flow exit 5. Strengthen the connection between the flow exit and the flexible exhaust duct with screws 6. Lift and hang the hood to the wall bracket and please ensure it sits firmly on the bracket 7.
Page 14
START USING YOUR COOKER HOOD Touch control with LED display - GESTURE Gesture Control:When the hood is off, wave your hand from left to right or right to left to open it. Hood will work under hight speed and light will be turned on.When the hood is working, wave your hand from left to right or right to left to turn it off.
Page 15
Refit mains power cable to power Light does not work, Mains power cable is loose or outlet. motor does not work disconnected Switch power outlet on. One way valve and the outlet are Take down the one way valve and not tightly sealed seal with sealant.
Page 16
Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly crisscross scratching patterns from appearing. CONTROL PANEL SURFACE The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning.
Page 17
THE OIL CUP • Your cooker hood includes a unique oil cup which collects the oil that is deposited on the grease filters. • When the oil cup is about 2/3 full the oil cup needs to be cleaned. • Take away the oil cup, by slightly pulling the oil cup forwards to release it from the Cooker hood.
Page 18
Changing the lights: • Remove the grease filter. • Use a screwdriver to remove the 4pcs screws on the large glass and carefully remove the glass. • Then slightly pull the light connecting wire out, and dismantle the terminal of the light connecting wire.Replace the lamp.
Need help?
Do you have a question about the HC-ARIA-90 and is the answer not in the manual?
Questions and answers