Content 1…………………………………..………………………………Safety instructions 2…………………………………..………………………………Installation 3…………………………………..………………………………Start using your cooker hood 4…………………………………..………………………………Troubleshooting 5…………………………………..………………………………Maintenance and cleaning 6…………………………………..………………………………Environment protection...
SAFETY INSTRUCTIONS his manual explains the proper installation and use of your cooker hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. monoxide poisoning.
Page 4
● arning: Before obtaining access to terminals, all supply circuits must be disconnected. Always to do: ● lways put lids on pots and pans accessible parts can become hot during when cooking on a gas cooker. operation. Be careful to avoid touching ●...
Page 5
INSTALLATION (VENT OUTSIDE) If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or non- flammable material with an interior diameter of 120mm) Before installation, turn the unit off and unplug it from the outlet.
Page 6
Method B: 1. Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard. 2. Put the outlet to the cooker hood, then install the cooker hood on the bottom of the cupboard, tighten the cooker hood with enclosed 4 screws. 3.
WARNING: ➢ For safety reason, please use only the same size of fixing or mounting screws which are recommended in this instruction manual. ➢ Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
The distance between the Refit the cooker hood to the Insufficient suction cooker hood and the gas top is correct distance. too far The Cooker hood The fixing screw is not tight Tighten the hanging screw and inclines enough make it horizontal. NOTE: Any electrical repairs to this appliance must conform to your local, state and federal laws.
Page 9
GREASE MESH FILTERS The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with a mild detergent and then brush it gently with a soft brush. Do not apply too much pressure so as to avoid any damage to it . (Leave to dry naturally out of direct sun light) Filters should be washed separately to crockery and kitchen utensils.
Page 10
NOTE: • Make sure the filter is securely locked. Otherwise, it would loosen and cause danger. • When activated carbon filter attached, the suction power will be lowered. BULB REPLACEMENT The bulb must be replaced by the manufacturer, its Important : service agent or similarly qualified persons.
ENVIRONMENTAL PROTECTION This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU.
Need help?
Do you have a question about the HF-HSM102AT-60 and is the answer not in the manual?
Questions and answers