QB-V850ESFJ3 Preliminary User's Manual
ZUD-CD-05-0149
34/57
<6> Since the length of the GND wire below the head (insulated part) is approximately 60 mm, there must
be at least a GND to which it can be connected to within the range of the three approximately 60 mm
radius sections of the target system for connecting the extension probe, as shown in Figure 2-9. The
GND wire of the extension probe is soldered to positions J and K in Figure 2-9. To connect it to
position L, remove the wire soldered to J or K and then solder it to L.
Figure 2-9. Where GND Wire Can Be Connected
Target system