Seiko Astron GPS SBXA038-1 Basic Manual page 16

Table of Contents

Advertisement

6
TROUBLESHOOTING
 Set the date to  1  (1st) ( ⑤ , ⑥ )
5
Continue to press Button B and C simultaneously 
(3 sec) and release them when the second hand 
moves to the 13-sec position
The watch enters the mode to adjust 
the preliminary position of the date.
※   N ever pull 
Button
the crown 
B
out.
Press for 3 sec 
simultaneously
※   D uring movement of 
Button
the date, the buttons 
C
cannot be operated.
 Set the indicator hand to  E  ( ⑦ 〜 ⑨ )
7
Continue to press Button A (2 sec), 
8
Press Button B or C to adjust the 
and release it when the second 
indicator hand as shown in the fi  gure
hand moves to the 55-sec position
The watch enters the mode to adjust the 
Adjust the indicator hand to the position as shown in the fi  gure.
preliminary position of the indicator hand.
※   I f the indicator 
hand points as 
Press
for
shown in 
2 sec
the fi  gure, 
go to 
operation 
of ⑨ .
※ The indicator hand makes one complete 
turn, but this does not mean a failure.
 Set the time ( ⑩ )
10
Set the time by receiving GPS signals
When you are in a place where GPS 
When you are in a place where GPS signals can be 
signals cannot be received
easily received (P. 13), adjust the time zone.
① Carry out manual time zone setting
→ How to adjust the time zone P.40
 → P.43
If GPS signals are received after the system reset, 
leap second data are also received. → P.48
6
※   I f   t h e   d a t e   i s   s t o p p e d 
Press Button B or C to set the 
continuously  for  1  minute  or 
longer, the watch automatically 
date to  1
returns  to  the  time  display 
Adjust the date so that the position of  1  
mode.  When  the  watch  has 
returned  to  the  time  display 
will locate at the center of the window.
mode, restart operation.
To
※   I f  1  is displayed, go to 
advance
※   I f  no  operation  is  performed 
operation of ⑦ .
the date
for  more  than  1  minute  or 
slightly
when  Button  A  is  pressed 
If the button is kept pressed 
once,  the  watch  returns  to 
for 2 seconds, the date 
the time display mode.
moves continuously.  Press 
To
W h e n   t h e   w a t c h   h a s 
the button again to stop the 
return
returned  to  the  time  display 
the date
date.
slightly
mode, restart operation.
9
When operation is completed, press 
Button A and then release it
The mode to adjust 
Button
the preliminary 
To move
the hand
position is 
clockwise
completed, and the 
If the button is 
second hand and 
kept pressed for 
2 seconds, the 
hour/minute hands 
hand moves 
start moving.
continuously.  
To move
 the hand 
Press the button 
※   I f  no  operation  is  performed  for  more  than  1 
counter-clock
minute  or  when  Button  A  is  pressed  once,  the 
again to stop the 
wise
watch returns to the time display mode.
hand.
   W hen the watch has returned to the time display 
mode, restart operation.
After operation of ① to ⑨ is completed, make sure to set the time.
When  the  time  and  date  are  set, 
operation is completed.
Manually set the time → P.52
Manually set the date → P.53
58
7
SPECIFICATIONS
1.Basic function ・・・・・・・・・・・・・・・・・・・・・・  M ain-dial  ;  three  hands  (hour/minute/second  hands),  date  display, 
2.Frequency of crystal oscillato ・・・・・・・・32,768 Hz (Hz = Hertz ... Cycles per second) 
3.Loss/gain (monthly rate)  ・・・・・・・・・・  L oss / gain ± 15 seconds on a monthly rate (Except the case when 
4.Operational temperature range ・・・・Between − 10℃ and +60℃
5.Driving system ・・・・・・・・・・・・・・・・・・・・・  S tep  motor  (hour/minute/second  hands  of  main-dial,  date,  indicator 
6.Power source  ・ ・・・・・・・・・・・・・・・・・・・・・・Secondary battery, 1 piece 
7.Duration of operation ・・・・・・・・・・・・・・・  A pproximately 6 months (Fully charged, and the Power Save is not 
 
 
A
8.GPS signal reception function  ・・・・・  T ime  zone  adjustment,  manual  time  adjustment,  automatic  time 
9.IC (Integrated Circuit)・・・・・・・・・・・・・・Oscillator, frequency divider and driving circuit C-MOS-IC, 4 pieces
SPECIFICATIONS
indicator hand, sub-dial ; two hands (hour/minute hands) 
the  watch  is  used  without  an  automatic  time  setting  by  receiving 
GP S  signal  and  when  it  is  worn  on  the  wrist  within  a  normal 
temperature range between 5℃ and 35℃ ).
hand, hour/minute hands of sub-dial)
activated).
※   I f the Power Save is activated after it is fully charged, the watch
continues to run for approximately 2 years at maximum.
adjustment
※ The specifi  cations are subject to change without prior notice for product improvement.
59

Advertisement

Table of Contents
loading

Table of Contents