Electrolux ENN26800 User Manual page 12

12 electrolux
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
1
5
Important! The wires in the mains lead are
coloured in accordance with the following
code:
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth sym-
bol or coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
"N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
is secure over the outer sheath.
2
3
4
Earth
Live
Neutral
4
5. Make sure the electricity supply voltage
is the same as that indicated on the ap-
pliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp
2
plug fitted . In the event of having to
change the fuse in the plug supplied, a 13
amp ASTA approved (BS 1362) fuse must
be used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
REMOVING THE SHELF HOLDERS
Your appliance is equipped with shelf re-
tainers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction
of the arrow (A).
2. Raise the shelf from the rear and push
it forward until it is freed (B).
3. Remove the retainers (C).
DOOR REVERSIBILITY
The door of the appliance opens to the
right. If you want to open the door to the
left, do these steps before you install the
appliance:
1. Loosen and remove the upper pin.
2. Remove the upper door.
3. Remove the spacer.
4. Loosen the middle hinge.
5. Remove the lower door.
6. Loosen and remove the lower pin.