Electrolux EWX 12550 W User Manual page 44

44 electrolux installation
The required dimensions are given in
the picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B)
supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by
means of the M5x15 screws (3-Fig. B).
The hinges can be adjusted to com-
pensate for possible uneven thickness
of the door.
To align the door perfectly it is neces-
sary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw
again.
d) Counter-magnet (6)
The appliance is pre-arranged for a
magnetic closure of the door. To
enable a correct operation of this
device, it is necessary to screw the
counter-magnet (6) (steel disk + rubber
ring) into the inner side of the door.
Its position must correspond to the
magnet (4) on the appliance (see pic-
ture D).
If the door has to be opened from left
to right, invert the position of the plates
(7), the magnet (4) and the plate (5)
(Fig. B and E). Mount the counter-mag-
net (6) and the hinges (1) as previously
described.
Recommendations regarding the
construction and fitting of a base
when the installation requires an
integrated appliance to be raised.
Where the appliance has been raised
by mounting onto a wooden base pro-
vided by the installer. The material used
to construct the base should have a
non slip surface, be water repellent and
if possible be one solid piece.
If it is not possible to use one solid
piece, due to the additional height
required, ensure that any additional
strips of timber are glued and screwed
to the underside of the base (see Fig.
F).