Quoizel GAR8406SS Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Alternate
B Mounting screw
x 2
Front/Back
D Glass Panel
x 2
-
STEP 1 Install Glass Panels
A. Install two Side Glass Panels (E) first.
And then install Front/Back Glass
Panels (D). Make sure smooth surface
of Glass Panels (D/E) are outside
during installation.
B. Insert the top edge of the Glass
Panels (D/E) into the slot in the side of
the Fixture Body (C). Secure the
Glass Panels (D/E) by folding tabs in
the bottom edge of the Fixture Body
(C) onto the bottom edge of the Glass
Panels (D/E).
Outside Surface is smooth,
Internal Surface is ribbed.
Figure 1
2019 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Crossbar
Assembly
x 1
Fixture Body
C
x 1
Side Glass
E Panel
x 2
visit us on-line at www.quoizel.com
Installation Guide #IS-GAR8406SS
For Style GAR8406SS
Care + Maintenance selection.
STEP 2 - Installing the Crossbar Assembly
A. Attach the Crossbar Assembly (A) to the outlet box with the head
of the green ground screw facing you. Secure the Crossbar
Assembly (A) with outlet box screws (not included). Tighten until
.
snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
Outlet Box
Mounting Screw
or Alternate Short
Mounting Screw
C
Figure 3
Slot
-
STEP 3 Test Fit the Backplate to the
Tab
Crossbar Assembly
A. Remove the mounting balls from the
Crossbar Assembly (A). Place the
backplate and Fixture Body (C) onto the
Crossbar Assembly (A) and secure with
E
mounting balls. Note: The backplate and
Fixture Body (C) should be snug against the wall and held tight with
the mounting balls. If it is not, adjust the length of the mounting
D screws or alternate short mounting screws on the Crossbar
Assembly (A) by unscrewing the preassembled hex nut and lock
washer and then screwing the mounting screws or alternate short
mounting screws in or out of the crossbar until the correct length is
achieved. Once the backplate and Fixture Body (C) is secure,
remove the mounting ball and Fixture Body (C).
1of2
Outlet Box Screws
(not included)
Hex Nut and
A
Lock Washer
Backplate
Mounting Screw
or Alternate Short
Mounting Screw
ReleasedDate:2019-03-20
Figure 2
A
Mounting Ball
C