Quoizel GRD8405W Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: LED 18W
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
Crossbar
A
x 1
Mounting Screw
B
x 2
STEP 1 - Install the Crossbar to the junction box
A. Attach the Crossbar (A) to the Outlet Box with the head of the Green
Ground Screw facing you. Secure it with Outlet Box Screws (not
included), tighten until snug.
Outlet Box
Green Ground Screw
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
Green Ground Screw
on the Crossbar
2018 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Fixture Body
C
x 1
Supply Wires
with Ground Wire
Outlet Box Screws
(not included)
A
Figure 1
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Figure 2
visit us on-line at www.quoizel.com
Installation Guide #IS-GRD8405W
For Style GRD8405W
Care + Maintenance selection.
STEP 3 - Install the Fixture Body
A. Place the backplate of the Fixture Body (C) onto the Crossbar (A)
and secure with Mounting Screws (B). Tighten until snug with
screwdrivers.
STEP 4 - Apply Silicone Sealer
A. Make sure the exterior wall surface and fixture backplate are free of
dirt before applying caulk. Using exterior grade caulk, caulk over top
of backplate and down both sides. Do not caulk the bottom of the
fixture backplate to ensure proper moisture drainage.
Your fixture is now assembled and ready to use. Enjoy!
Exterior Grade Caulk
Exterior Grade Caulk
1of2
Backplate
A
B
Figure 3
Backplate
Figure 4
ReleasedDate:2018-08-29
C
C