Quoizel GDM8406PN Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base bulb 100W Maximum, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture.
purchase.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Handle
B
x 1
-
STEP 1 Install Handle
A. Remove Styrofoam inside of the cage.
B. Remove lock screws from the Fixture Body (C).
C. Attach the Handle (B) to the Fixture Body (C) and secure by
threading lock screws back into mounting holes on the Fixture
Body (C). Hand tighten until snug.
Figure 1
2018 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Crossbar
Assembly
x 1
Fixture Body
C
x 1
B
Lock Screw
Mounting Hole
C
Styrofoam
(Remove)
visit us on-line at www.quoizel.com
Installation Guide #IS-GDM8406PN
For Style GDM8406PN
Care + Maintenance selection.
-
STEP 2 Installing the Crossbar Assembly
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug.
Outlet Box
Figure 2
-
STEP 3 Test Fit the Backplate to the Crossbar Assembly
A. Remove the mounting balls from the Crossbar Assembly (A). Place
the backplate and Fixture Body (C) onto the Crossbar Assembly (A)
and secure with mounting balls. Note: The backplate and Fixture
Body (C) should be snug against the wall and held tight with the
mounting balls. If it is not, adjust the length of the mounting screws
on the Crossbar Assembly (A) by unscrewing the preassembled hex
nut and lock washer and then screwing the mounting screws in or
out of the crossbar until the correct length is achieved. Once the
backplate and Fixture Body (C) is secure, remove the mounting ball
and Fixture Body (C) and proceed to Step 4.
Mounting Screw
1of2
Missing Parts? Contact your original place of
Supply Wires
with Ground Wire
A
Outlet Box Screws
(not included)
Backplate
A
Hex Nut and
Lock Washer
Figure 3
Mounting
Ball
C
ReleasedDate:2018-04-04