UNIVIEW IPC931 Series Quick Installation Manual page 5

Install waterproof cables in accordance with the following instructions. The user assumes all responsibility for damage to the equipment caused by water as a result of improper
NOTE!
Before you begin, connect all the necessary cables and insulate the

copper wires that you do not use.
Use self-adhesive waterproof tape (not included) to protect the cables.

Use waterproof components to protect the Ethernet cable.

Notification!
Before stretching the cable through the coupling, insert a rubber sealing
ring.
4. If the camera is equipped with a DC power connector and you will not use it, insert a blanking plug into the connector (When powering the camera using PoE).
5. (Optional) When the waterproof treatment is complete, insert the cables into the waterproof junction box (purchased separately).
WARNING!
Connectors must be kept away from water.

Insert the power adapter into a waterproof distribution box or install it

indoors.
5 z 35
EN Resistance requirements
installation.
1. Insulating tape (not included) to insulate the connection part of each cable.
2. Waterproof cables with self-adhesive waterproof tape.
(1) Fully stretch the waterproof tape at both ends.
(2) Insulate joints and cables tightly with waterproof tape.
(3) Tighten the tape at both ends to prevent water from entering.
3. Install the supplied waterproof components on the network cable.