Craftsman 580.76201 Owner's Manual page 3

CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CAN+
NOT CONTACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SEI-rlNG UP,
TRANSPORTING, ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.
---] CAUTION: Before using this product,
read this manual and follow all Safety
Rules and Operating Instructions.
Engineexhaust gases containDEADLY carbon monoxide
gas. This dangerous gas, if breathed in sufficient concen-
trations, can cause unconsciousnessor even death.
Operate this equipment only in the open air where ade-
quate ventilation is available.
Gasoline is highly FLAMMABLE andits vapors are
EXPLOSIVE. Do not permit smoking, open flames, sparks
or heat in the vicinity while handlinggasoline. Avoid
spilling gasoline on a hot engine. Allow unit to cool for 2
minutes before refueling. Comply with all laws regulaflng
storage and handling of gasoline.
The muffler and engine will heat up during operation and
remain hot immediately aftershutting it down. Avoid any
contact with a hot muffler or engine or you could be
severely burned.
The high pressure equipment is designed to be used with
Sears authorized partsonly. If you use this equipment with
parts that do not comply with minimum specifications, the
user assumes all risks and liabilities.
Operate engine only at governed speed. Running engine
at excessive speeds increases the hazard of personal
injury. Do not tamper with parts which may increase or
decrease the governed speed.
Before starting the Pressure Washerin cold weather,
check all parts of the equipment and be sure ice has not
formed there.
The muffler and air cleanermust be installed and in good
condition before operating the Pressure Washer. These
components act as spark arrestors if the engine backfires.
Check fuel system for leaksor signs of daterioration such
as chafed or spongy hose, loose or missing clamps or
damaged tank or cap. Correct all defects before operating
the Pressure Washer.
Units with broken or missing parts, or without protective
housing or covers should NEVER be operated.
Do not adjust unloader valve to a pressurein excess of
machine raflng.
Operate the pressure at no more than the PSI fluid
pressure rated for your pressure washer.
High pressure spray can cause paint chips or other
particles to become airborne and fly at high speeds.
High pressure spray may damage fragile items including
glass. Do not point spray gun at glass when in the jet
spray mode.
Never move the machine by pulring on the high pressure
hose. Use the handle provided on the top of the unit.
Keep the hose connected to machine or the spray gun
while the system is pressurized. Disconnecting the hose
while the unit is pressurized is dangerous.
Always be certain the spray gun, nozzles and accessories
are correctly attached.
Hold the spray gun firmly in your hand before you start the
unit. Failure to do so could result in an injury from a whip-
ping spray gun. Do not leave the spray gun unattended
while the machine is running.
Never use a spray gun which does not have a trigger lock
or trigger guard in place and in working order.
Do not secure trigger gun in the puU-back(open) posiUon.
Keep water spray away from electdc wiring or fatal electdc
shock may resutt.
The cleaning area should have adequate slopes and
drainage to reduce the posaibiiity of a fall due to slippery
surfaces.
Locate this pressure washer in areas away from any
combustiblematerials, combustiblefumes or dust.
Do not spray flammable liquids.
Some chemic_s or detergentsmay be harmful if inhaled
or ingested, causing severe nausea, fainting or poisoning.
These harmful elements may also cause propertydamage
or severe injury.
Use a respiratoror mask whenever there is a chance that
vapors may be inhaled. Read all instructions with the mask
so you are certainthe mask will providethe necessary pro-
tecflonagainst inhaling harmfulvapors.
AJwayswear eye pmtectk_ when youuse this equipmentor
when youare in the vicin_.y where the equipment i s in use.
Do not wear loose clothing,jewelry or anythingthat may
be caught in the starter or other rotatingparts.
Do not allow CHILDREN to operate the PressureWasher
at any time.
Never aim the gun at people, animals or plants.
This equipment produces high pressurestreams of fluid
which can pierce the skin and itsunderlying tissues,
leading to sehous injury and possible amputation.
Never allow any part of the body to come in contact with
the fluid stream. DO NOT come in contact with a fluid
stream created by a leak in the high pressure hose.
Do not by-pass any safety device on this machine.
MAINTENANCE AND STORAGE:
Operate and storethis unit on a stable surface.
High pressure hose can developleaks from wear, kinking,
abuse, etc. Water spraying from a leak is capable of inject-
ing material into skin. Inspect hoseeach Umebefore using
it. Check all hoses for cuts, leaks, abrasions or bulging of
cover,or damage or movement of couplings,if any of
these conditionsexist, replace hose immediately. Never
repairhigh pressure hose. Replace it with anotherhose
that meets minimum pressure rating of your pressure
washer.
A LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. I
A
IT MEANS "A'I-I'ENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED."
3