Makita XWT08Z Instruction Manual page 8

Reversing switch action
A
► 1. Reversing switch lever
Changing the impact force
2
3
4
► 1. Changed in three steps 2. Hard 3. Medium 4. Soft
5. Button
You can change the impact in three steps: hard, medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Specifications of each impact force grade
Impact force grade displayed on
panel
Hard
Medium
Soft
B
1
1
5
is pressed, the number of blows changes in three steps.
Maximum blows
XWT07 / XWT08 /
XWT07XV XWT08XV
2,200 min
2,000 min
1,800 min
CAUTION:
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
XWT09 /
XWT09XV
-1
(/min) Tightening when force and speed are desired.
-1
(/min) Tightening when you need good controlled power.
-1
(/min) Tightening when you need fine adjustment with
small diameter bolt.
7 ENGLISH
Always check the direction of
Use the reversing switch only after
When not operating the tool,
Application