Table of Contents
Advertisement
Before installation, check to ensure that the area you are installing the speaker is free of any ceiling joints, by
tapping the ceiling or using a stud finder.
If you wish to paint the speaker frame and grill, please refer to page 7 "PAINTING THE SPEAKER FRAME AND
GRILL" before proceeding.
1
Position the cutout template where you are
installing the speaker. Then trace around the
template with a pencil.
TEMPLATE
2
Drill a pilot hole in the center outline you traced.
3
Insert the bent coat hanger wire into the hole.
Then slowly rotate to check for any obstruction. If
there is any obstruction, patch the hole and
select another location.
4
NS-IW280C
INSTALLATION
360
o
4
Cut the ceiling along the outline you traced.
5
Run high quality speaker cable from your
receiver to your speakers. Leave a few extra feet
of cable.
Note:
You can insulate the cavity by placing a sheet of
fiberglass insulation around the speaker
components to improve speaker performance.
Advertisement
Chapters
Table of Contents
