Ricoh 1018 Operating Instructions Manual page 37

Menu
Resolution
Toner Saving
❖ ❖ ❖ ❖ System
Menu
Print PS Errors
I/O Timeout
I/O Buffer
Description
You can set the print resolution in dots per inch.
❖ ❖ ❖ ❖ PCL
300 dpi, 600 dpi
❖ ❖ ❖ ❖ PS
300 dpi, 600 dpi
Note
❒ Default: 600 dpi
❒ The setting in the printer driver takes priority of the setting on
control panel.
You can select whether to enable Toner Saving.
• Off
• On
Note
❒ Default: Off
❒ If "Toner Saving" is "On", "EdgeSmoothing" is ignored even
if it is "On".
❒ The setting in the printer driver takes priority of the setting on
control panel.
Description
You can set whether the PS error sheet should be printed out.
• Off
• On
Note
❒ Default: Off
You can set how many seconds the printer should wait before
ending a print job. If data from other port often appears in the
middle of the print job, you should increase the timeout value.
15 seconds, 30 seconds, 60 seconds, 180 seconds, 300 seconds
Note
❒ Default: 30 seconds
You can set the size of the I/O Buffer. Normally it is not necessary
to change this setting.
16 KB, 32 KB, 64 KB, 128 KB, 256 KB, 512 KB
Note
❒ Default: 32 KB
Printer Features Parameters
4
29