Section Ii - Assembly Instructions - MACKISSIC RT1450IC Owner's Manual

SKID
TILLER OWNER'S MANUAL
HANDLE BARS ENGINE MANUAL
TIE BARS WARRANTY CARD
SHIFT ROD CROSS BRACE
POLYBAG CLUTCH CONTROL LEVERS 5 EA - 5/16-18 NYLOCK NUT
TOOLS REQUIRED FOR ASSEMBLY

STEP I – UNPACKING
1. Remove the tiller from its crate.
2. Compare all items with the list above.
3. If any parts are missing or damaged, contact your local dealer, distributor or place of purchase.
4. Assembly should be done on a clean, level surface.
STEP II – ASSEMBLY
NOTE: ONLY HAND TIGHTEN THE HARDWARE IN THIS SECTION.
TIGHTENING BEFORE EVERYTHING HAS BEEN ATTACHED COULD PREVENT
1. Cut cable ties that secure both clutch cables and the throttle cable to the hitch.
2. Remove the eyebolt from the front of the transmission that holds the throttle cable.
SECTION II – ASSEMBLY INSTRUCTIONS
POLYBAG
2 EA - CLUTCH SPRING
4 EA - 3/8-16 X 1-1/4" HHCS
4 EA - 3/8 NYLOCK NUTS
4 EA - 5/16-18 X 1-3/4" HHCS
4 EA - 5/16 FLAT WASHER
2 EA - 10-32 KEP NUT
2 EA - 10-32 X 1-1/4" RHMS
1 EA - 5/16-18 X 5" EYE BOLT
1 EA - 3/8-24 HEX NUT
2 EA - 1/4-20 X 1-1/2 HHCS
2 EA - 1/4-20 NYLOCK NUT
CORRECT ASSEMBLY.
BOLT BAG PART #
710-1848 CLUTCH CONTROL LEVERS
090-0111 HANDLES
090-0461 HANDLES
090-0091 CROSS BRACE
090-0460 4 - CROSS BRACE
090-0233 CROSS BRACE
706-1539 THROTTLE CONTROL
090-0400 THROTTLE CONTROL
090-0268 RH HANDLE
090-0267 SHIFT ROD
090-0057 CLUTCH CONTROL LEVERS
090-0470 CLUTCH CONTROL LEVERS
8
WHERE USED
1 - SHIFT ROD EYEBOLT