Maintenance Schedule - MACKISSIC RT1450IC Owner's Manual

Merry rear tine tiller
Table of Contents

Advertisement

Frequency
After every rental
Inspect belts & pulleys for proper alignment and excessive wear
Check operation of belts and idlers, make sure tines & wheels stop & start
correctly
Inspect tine transmission for any leakage, check all bolts for tightness. Pay
particular attention to center bolt that secures the transmission to the frame
rails
Check tines for wear and excessive play, make sure no pins are missing,
inspect tine shafts for any leakage, if noted inspect tine shaft seals
Remove front bottom housing, clean out any dirt or residue, lubricate drive
chain, chain tensioner and shift linkage with appropriate grease or
lubricant. Inspect drive transmission for wear and leakage.
Perform normal engine maintenance
Every 150 hours
Inspect tine transmission case assembly, conduct test for excessive travel,
(see attached). Check for excessive wear on case halves
Check tine shaft and drive shaft for up and down play, if loose replace
bearings.
If transmission is OK replace tine shaft and drive shaft seals
Inspect tines for wear, if cutting corner is rounded replace tines. Check pin
holes for elongating and wear, make sure no pins are missing
Check oil level in right angle drive
Anytime the transmission is unbolted from the frame rails it is necessary to
secure the internal sprockets with a 5/16" rod cut to the same width of the
transmission case. It is possible for the internal sprockets to move if not
secured during service
Every 600 Hours
Remove transmission for internal inspection. Disassemble and inspect all
parts for wear. Clean all parts, replace worn parts as needed, relubricate
with approx. 9 oz."00" grease. Reassemble with new case gasket and
reinstall on tiller.
Anytime the transmission is unbolted from the frame rails it is necessary to
secure the internal sprockets with a 5/16" rod cut to the same width of the
transmission case. It is possible for the internal sprockets to move if not
secured during service
Drain and replace oil in right angle drive

MAINTENANCE SCHEDULE

19
Service required

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rt83h

Table of Contents