Table of Contents
Advertisement
OPERATING INSTRUCTIONS
STARTING:
Adjust drag bar for proper depth and tilling
conditions.
Make certain that both handle levers have
dropped into disengage position.
Place shift arm in N (neutral) position.
Move throttle to RUN position.
Move choke to CHOKE position.
Move engine ON/OFF switch to ON position.
Stand to side of tiller and pull starter rope.
As engine starts move choke lever to RUN.
Move throttle to desired speed.
TILLING:
Make certain that both handle levers have
dropped into disengage position.
Place shift arm in 1 (first gear).
Move throttle to ¾ speed.
Engage left hand lever to engage wheels.
Engage right hand lever to engage tines.
Adjust downward pressure on dragbar as
required.
For difficult tilling conditions and breaking fresh
sod, put the dragbar foot in the up position.
For normal tilling conditions, use the dragbar
Foot in the down position.
STOPPING:
Release both handle levers.
Place shift arm in N (neutral) position.
Move throttle to slow or stop.
Turn engine switch to OFF.
REVERSE:
Release both handle levers.
Check behind for any obstacles.
Reduce throttle speed.
Place shift arm in R (reverse) position.
Engage left hand lever to engage wheels.
TRANSPORT:
Release both handle levers.
Place shift arm in 3 (3
Engage left hand lever to engage wheels.
DO NOT TILL IN 3
PART # 712-0074
712-0074
PART # 091-0085
4
rd
gear).
RD
GEAR.
Advertisement
Table of Contents
