Gigabyte H262-NO1 User Manual page 96

Parameter
PCH Configuration
PCH SATA Configuration
PCH SATA Configuration
(Note 1) Only appears when HDD sets to RAID Mode.
(Note 2) Only Supported when HDD is in AHCI or RAID Mode.
BIOS Setup
Description
Press [Enter] to configure advanced items.
SATA Controller
Š
– Enable/Disable SATA controller.
– Options available: Enable, Disable. Default setting is Enable.
Configure SATA as
Š
– Configures on chip SATA type.
– AHCI Mode: When set to AHCI, the SATA controller enables its AHCI
functionality. Then the RAID function is disabled and cannot be access
the RAID setup utility at boot time.
– RAID Mode: When set to RAID, the SATA controller enables both its
RAID and AHCI functions. You will be allowed to access the RAID
setup utility at boot time.
– Options available: AHCI, RAID. Default setting is AHCI.
Alternate Device ID on RAID
Š
– Enable/Disable Alternate Device ID on RAID mode.
– Options available: Enable, Disable. Default setting is Disable .
SATA Port 0/1/2/3/4/5/6/7
Š
– The category identifies SATA hard drives that are installed in the
computer. System will automatically detect HDD type.
Port 0/1/2/3/4/5/6/7
Š
– Enable/Disable Port 0/1/2/3/4/5/6/7 device.
– Options available: Enable, Disable. Default setting is Enable.
Hot Plug (for Port 0/1/2/3/4/5/6/7)
Š
– Enable/Disable HDD Hot-Plug function.
– Options available: Enable, Disable. Default setting is Enable.
Spin Up Device (for Port 0/1/2/3/4/5/6/7)
Š
– On an edge detect from 0 to 1, the PCH starts a COM reset
initialization to the device.
– Options available: Enable, Disable. Default setting is Disable.
(Note 1)
(Note 2)
- 96 -
(Note 2)