Samsung SCX-6322DN/XAZ Service Manual page 53

Alignment & Adjustments
Message
[Line Error]
Low Heat Error
Cycle Power
LSU Motor Error
Cycle Power
LSU Hsync Error
Cycle Power
Main Motor Locked
Mail Exceeds
Server Support
Memory Full
MP Tray
Paper Empty
Network Error
[No Answer]
Not Assigned
[No Paper] Add Paper
One Page is Too Large
Open Heat Error
Cycle Power
Operation Not
Assigned
Over Heat Error
Cycle Power
Paper Jam 0
Open/Close Door
Paper Jam 1
Open/Close Door
Paper Jam 2
Check Inside
Power Failure
Service Manual
4-26
Meaning
Your machine cannot connect with the
receiving fax machine or has lost contact
because of a problem with the phone line.
There is a problem in the fuser unit.
A problem has occurred in the LSU (Laser
Scanning Unit).
A problem has occurred in the LSU (Laser
Scanning Unit).
There is a problem in the main motor.
The mail size is larger than the supported
size by SMTP server.
The memory is full.
There is no paper in the multi-purpose tray.
There is a problem with the network.
The receiving fax machine has not answered
after several redial attempts.
The one-touch dial or speed dial number you
tried to use has no number or email address
assigned to it.
The paper in the tray has run out.
Single page data exceeds the configured
mail size.
There is a problem in the fuser unit.
You are in the Add Page/Cancel Job
operation, but there are no jobs stored.
There is a problem in the fuser unit.
Paper has jammed in the feeding area of the
tray.
Paper has jammed in the fuser area.
Paper has jammed in the paper exit area.
Power has turned off then on and the
machine's memory has not been back up.
Suggested solutions
Try again. If the problem persists, wait an
hour or so for the line to clear and try again.
Or, turn the ECM mode on.
Unplug the power cord and plug it back in. If
the problem persists, Replace to the Fuser
Unit
Unplug the power cord and plug it back
inches. If the problem persists, Replace to
the Fuser Unit
Unplug the power cord and plug it back
inches. If the problem persists, Replace to
the Fuser Unit
Open and then close the front cover.
Divide your mail or reduce the resolution.
Delete unnecessary fax jobs and retransmit
after more memory becomes available.
Alternatively, split the transmission into more
than one operation.
Load paper in the multi-purpose tray.
Contact your network administrator.
Try again. Make sure that the receiving
machine is operational.
Enter the number or email address manually
using the number keypad or store the
number or address.
Load paper in the tray.
Reduce the resolution and try again.
Unplug the power cord and plug it back in. If
the problem persists, Replace to the Fuser
Unit
Check the display to see if there are any
scheduled jobs.
Unplug the power cord and plug it back in. If
the problem persists, Replace to the Fuser
Unit
Clear the jam.
Clear the jam.
Clear the jam.
The job which you were trying to do before
the power failure must be completely
re-done.
Samsung Electronics