Care, Cleaning And Storage - Breville Power Blender BLR50 Instruction Booklet

CARE, CLEANINg & StoRAgE PAge heAder.....
Jug and lid
In order to keep your jug clean and avoid
food drying on the blades and jug, follow the
below steps as soon as possible after use:
• Rinse most of the ingredients off the jug
and lid.
• 500ml of warm water and turn the dial
to speed 5 for 60 seconds. If thick or
sticky ingredients require extra cleaning
power add a few drops of dish liquid
detergent.
• Rinse the jug and lid again and/or wash
separately in warm soapy water with a
soft cloth or bottle brush.
• It is most effective to clean the jug
immediately after use.
Blades and silicon seal
To maintain a clean jug, the blades and
silicon seal must be disassembled and
washed after each use.
Use caution when cleaning, as the blades are
very sharp.
Motor base
To clean the motor base, wipe with a soft,
damp cloth then dry thoroughly. Wipe any
excess food particles from the power cord.
10
Cleaning agents
Do not use abrasive scouring pads or
cleaners on either the motor base or the jug,
as they may scratch the surface. Use only
warm soapy water with a soft cloth.
Dishwasher
The blender jug and lid can be washed in
the dishwasher on a standard wash cycle.
Jug can be placed on the bottom shelf,
however the lid and inner measuring cap
should be washed on the top shelf only.
Stubborn food stains and odours
Strong smelling foods such as garlic, fish
and some vegetables such as carrots may
leave an odour or stain on the blender jug
and lid. To remove, soak blender jug and lid
for 5 minutes in warm soapy water. Then
wash with a mild detergent and warm water,
rinse well and dry thoroughly. Store jug with
the lid off.
Storage
Store your blender upright with the blender
jug assembled on the motor base, or beside
it. Do not place anything on top. To allow air
to circulate, keep the lid off.