Table of Contents
Advertisement
Steps
1. Flip the M.2 2230 solid-state drive holder and align the notch on the M.2 2230 solid-state drive with the tab on the M.2
2230 solid-state drive holder.
2. Replace the single screw (M2x2) that secure the M.2 2230 solid-state drive to the M.2 2230 solid-state drive holder.
3. Slide the M.2 2230 solid-state drive into the M.2 card connector on the system board.
4. Align the screw hole on the M.2 2230 solid-state drive holder with the screw hole on the palm-rest and keyboard assembly.
5. Replace the screw (M2x3) to secure the M.2 2230 solid-state drive holder to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
This procedure applies only to systems shipped with a M.2 2280 solid-state drive installed.
NOTE:
The M.2 solid-state drive that is installed on your system depends on the configuration ordered. Supported card
configurations on the M.2 solid-state drive slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
The following images indicate the location of the M.2 2280 solid-state drive and provide a visual representation of the removal
procedure.
22
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
