GAS HOT PLATE Important For Future Reference Please complete this information and retain this manual for the life of the equipment. For Warranty Service and/or parts, this information is required. Model Number Serial Number Date Purchased WARNING: For your safety, do not store or use gasoline AVERTISSEMENT: Pour votre sécurité, ne pas stocker ni or other flammable vapors or liquids in the vicinity of utiliser d'essence ou d'autres vapeurs ou liquides...
If you have questions concerning the installation, operation, maintenance or LOCATION OF DATA PLATE service of this product, please contact WINCO®. The data plate is located on the rear or side panel. IMMEDIATELY INSPECT FOR SHIPPING DAMAGE All containers should be examined for damage before and during unloading.
Safety Precautions DANGER: This symbol warns of imminent hazard which Risque: Ce symbole avertit du danger imminent qui peut will result in serious injury or death. entraîner des blessures graves ou la mort. WARNING: This symbol refers to a potential hazard AVERTISSEMENT: Ce symbole indique un danger potentiel or unsafe practice, which could result in serious injury ou une pratique dangereuse, qui peut entraîner des...
Installation These instructions should be followed at all times. Failure to follow these Leg Installation: instructions could result in injury to yourself and others. The Hot Plate must not be operated without the legs attached. INSTALLATION CODES AND STANDARDS 1. Install adjustable legs by screwing leg post into recess nut at each corner The Hot Plate Range must be installed in accordance with: of unit frame.
Gas Connection: Combustible clearances: 1. The data plate on rear or side of the Hot Plate indicates the type of gas the unit is equipped to burn. DO NOT connect to any other gas type. 6" sides (152 mm) 6" rear (152 mm) 4"...
Note Conversion PLEASE CHECK LEAKAGE BEFORE RE-INSTALLING CONTROL PANEL. 2. Unscrew bolts and pilot valve, then remove the manifold (Fig.4). Lighting Instructions LIGHTING PILOT The pilot light on the appliance has been set at the factory. A screwdriver may be required for the first lighting to adjust the flame for your elevation. Fig.4 Pilot valve 3.
Do not use hose or pressure wash to clean. water for 15 to 20 minutes. Then either brush with a wire brush or clean If the machine is damaged, it must be repaired by a WINCO Approved gas ports with a sharp-pointed metal instrument to ensure open ports.
Parts protected by the manufacturer or its agent are not to be adjusted by the installer unless the installer is an authorized service agent. If you have any questions or problems DO NOT send unit to WINCO® without first contacting our customer service department.
Spare Parts List MODELS: NGHP-2 / NGHP-4 / NGHP-6 GAS HOT PLATES NGHP-2 NGHP-4 NGHP-6 DESCRIPTION PART # PART # PART # Grate NGHP-P3 NGHP-P3 NGHP-P3 Burner NGHP-P4 NGHP-P4 NGHP-P4 Long Pilot Tube NGHP-P5 NGHP-P5 NGHP-P5 Short Pilot Tube NGHP-P6 NGHP-P6 NGHP-P6 Manual Gas Valve A18...
This warranty is given only to the first purchaser from a retail dealer. No 4. Use of generic or after-market parts. warranty is given to subsequent transferees. 5. Repairs made by anyone other than a WINCO® designated service provider. Warranty does not cover product failures caused by: failure to maintain, 6. Lubrication.
Need help?
Do you have a question about the Spectrum NGHP-2 and is the answer not in the manual?
Questions and answers