4.From the plastic cover (E), which is
used to cover the hinge with the
pivot pin, you must take away the
part as indicated in the drawing.
This operation is made easer since
there is, in the internal part of the
cover hinge lid a groove that
facilates
coomponent.
"Remove the part marked with DX,
if the pivot pin is inserted in the
right hinge, SX in opposite case."
Apply covers (C-D) on joint cover
lugs and into hinge holes. Snap
hinge covers (E) into position.
5.Separate parts Ha, Hb, Hc, Hd as
shown in the figure.
40
the
removal
of
this