Advertisement
Please download the driver and software from the flash driver included in the package.
It includes:
You can also download the documents from Googledrive: https://cn.hk.uy/P3v
Please visit www.foxalien.com for more CNC machine products.
Feel free to contact us for technical support if you come across any difficulty during assembly and using.
Model | Vasto |
Working Area | 400 x 400 x 100mm (15.75" x 15.75" x 3.94") |
Input Voltage | 110V/220V |
Input Current | 110V/10A; 220V/5A |
Spindle Power | 300W |
Spindle Speed | 11000 rpm/min |
Motor | NEMA23 |
Firmware Version | 1.1H |
Limit Switch | X, Y, Z |
Emergency Stop Switch | Yes |
Support OS | Windows XP, Windows 7, Windows 8, Windows 10, Linux, Mac OS |
Software | Grblcontrol(Candle), other GRBL compatible software |
Support Offline Control | Yes (Offline controller NOT included) |
Support Add-ons | Offline controller/Laser/router (NOT included) |
Driver Installation
To Determine your Machine's COM port
Double click to start Grblcontrol (Candle)
Connect USB cable to computer and machine, click Service->Port select COM port. Click "OK"
If Status becomes Alarm and [MSG: Check Limits] appears in the console at the same time, please check whether the limit switch is triggered. You can power off and release the limit switch manually or refer to release the limit via software.
Console window prints "CTRL+X" indicates that the connection is failed. Need to check whether the E-stop is pressed down. If yes, turn the E- stop clockwise, and then click "Unlock".
Console window prints ['$' for help]" if the connection is successful. Click "Unlock".
Open a G-code file, Preview G-Code
Click the direction button to move the bit to the surface of the object. The proper gap between the bit and object's surface is that only an A4 paper can move through tightly.
Turn the knob clockwise to increase the spindle speed.
Click "Send" to start engraving
Engraving Finished.
Thickness: 15mm
Place the probe as shown
Click "Zero XY"
Click Z-probe button to start detecting. After Z-probe detection finished. Remove Z-probe, click "Send" to start engraving.
Limit switch will trigger when the machine runs out of active working area.
Command window will show: "ALARM:1 [MSG: Reset to continue]"
Click "Reset"
Click "Unlock"
Click direction buttons to move the axis way from limit switch.
If status change to "Alarm" again, that means it does not entirely move away from the limit switch, just repeat the previous steps to unlock.
Press down E-stop when the machine malfunctions to avoid damage.
Rotate clockwise to release the E-stop.
Status in software will change to "Alarm".
Print "[MSG:'$H'|'$X' to unlock]"
Click "Unlock" to normal working status.
Facebook Group
Foxalien.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the VASTO and is the answer not in the manual?
Questions and answers