Table of Contents
Advertisement
Connecting the Receiver and
Installing the Default Drivers
To connect the receiver:
1 Remove the receiver from the back of the keypad.
2 Plug the USB receiver into an available USB port on
your computer.
For Windows® 98, follow any on-screen instructions to
complete the default driver installation.
For Windows® Me/2000/XP, the "Found New
Hardware" or "Auto-detect of a HID device" message
will appear to indicate the installation of the default
driver.
NOTE: You may need to establish a communication link
between the keypad and the receiver. See "Establishing
a Communications Link" on page 5.
Turning the Calculator/Keypad On
and Off
To power on the batteries, use the on/off switch located
on the back of the keypad.
To turn on the keypad, press the CE/AC key, located
directly above the number seven key.
To turn off the keypad in calculator mode, press the CE/AC
key for 2 seconds.
To power off the batteries, use the on/off switch located
on the back of the keypad.
Targus Wireless Calculator Keypad
4
Advertisement
Table of Contents
