BaByliss E890E - Beard Trimmer And Electric Shaver Manual

BaByliss E890E - Beard Trimmer And Electric Shaver Manual

Advertisement

BaByliss E890E - Beard Trimmer And Electric Shaver Manual

PRODUCT FEATURES

  • Trimmer blades: W-Tech - stainless steel
  • 1 cutting guide for 21 lengths (from 0.5 mm to 10.5 mm, in 0.5 mm increments)
  • Dual shaving head with nickel foils
  • 3-position switch: trimmer/off/shaver
  • Grooved wheel to adjust the cutting length
  • Accessories: adaptor, cleaning brush, protective cap, oil
  • Waterproof

IMPORTANT INFORMATION REGARDING THE NI-MH BATTERIES OF THIS UNIT
To obtain and maintain the longest battery autonomy possible, allow it to charge for 16 hours before using it for the first time and then approximately every three months. Full autonomy of the unit will only be obtained after three complete recharge cycles.

CHARGING THE APPLIANCE

  1. Plug the cord into the appliance and connect the transformer. Before using the appliance for the first time, allow it to charge for 16 hours. Make sure the appliance's switch in the OFF position
  2. Check that the charging indicator light is lit.
  3. A full charge provides a minimum of 45 minutes' use of the appliance.
  4. Subsequent charges should be 16 hours.

USE ON THE MAINS

To use the appliance on the mains, plug the cord into the unit. Plug the appliance, in the OFF position, into the mains, then switch it on (if the battery is very weak, wait about 1 minute).


Use only the adapter that is supplied with the appliance

USING THE TRIMMER

It is recommended to put the protective cap on the shaver head before using the trimmer head.
NOTE: Alway put the comb guide on BEFORE turning the trimmer on, and turn the trimmer off before removing it.
To remove or replace the comb guide, turn off the appliance, pull the guide up to remove it, press the guide down then turn the dial to put it on.
To adjust the cutting length of the appliance, turn the dial.

USING THE TRIMMER - Activating the trimmer mode
Activate trimmer mode.

You can change the cutting length at any time.
NOTE! Make sure you hold the comb flat againt the skin in order to guarantee an even cut.

Removable blades
To make cleaning easier, the BaByliss trimmer blades can be removed. Make sure the appliance is turned off and then remove the comb guide. Hold the trimmer with the blades facing up and remove them by pressing on the tips of the blades. Carefully brush the blades using the cleaning brush to remove hair.
USING THE TRIMMER - Using the removable blades

Self-lubricating blades
The blades of your trimmer have a reservoir pad for releasing the necessay amount of oil for proper operation of yourt trimmer, time after time. Nevertheless, it is recommended that it be refilled occasionally when you notice performance is not as high. Remove the blades as described above. Squeeze a few drops of BaByliss oil onto the pad. Then replace the blades on the trimmer.
The BaByliss oil is specially formulated for the trimmer, it does not evaporate nor does it slow the blades. It is possible to obtain replacement blades when these are worn out or damaged.
USING THE TRIMMER - Using Self-lubricating blades

USING THE SHAVER

For greater comfort, set the trimmer head's cutting guide to the lowest position before using the shaver head.

USING THE SHAVER - Activating the shaver mode
Activate shaver mode.

Stratch the skin of the area you wish to shave and move the shaver head over it, against the direction of your hair growth.

Removable foil
To make cleaning easier, the foil of the shaver head is removable. To remove it, press the fasteners on its sides using your thumb and your index and lift it up.
Remove remaining hair using the cleaning brush.
USING THE SHAVER - Using the Removable foil

WATERPROOF

For a greater comfort of use, your appliance is waterproof and can even be used in the shower. Easy to clean, it guarantees maximum hygiene.


  • Unplug the appliance before using or cleaning it in water.
  • The adaptor must be placed so it cannot fall into water.

MAINTENANCE

Regular maintenance of the appliance's blades will keep them in optimal working condition.

Washable
For maximum hygiene, the heads of the appliance can be washed in water. Move the comb guide away from the body of the unit slightly, remove the foil from the shaver head, then rinse the heads of the applaince under running water. The comb guide and the foil can be also be rinsed separately.

BABYLISS SARL
99 avenue Aristide Briand
92120 Mountrouge
France

www.babyliss.com

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download BaByliss E890E - Beard Trimmer And Electric Shaver Manual

Advertisement

Need help?

Need help?

Do you have a question about the E890E and is the answer not in the manual?

Questions and answers

Table of Contents